Yak about stuff. Just stuff.
124 posts Page 13 of 13
Previous 1 ... 9, 10, 11, 12, 13 Next
damn, a few of those pic's are giving me a stiffy, i mean, it's so clean!
just because it's a bad idea, doesn't mean it wont be a good time
May 2011

Applied a black semigloss top coat...

Image

Image

Image


Bare metal rear apron - ready for the paint shop...

Image

Image
May/June 2011

While the Bug was at the paint shop I took care of the transmission and the CV joint shafts...

New throw-out bearing installed...

Image


Replaced the damaged seal cap at the transmission's right side shaft flange...

Image

Image

Image


New transmission mounts and refurbished cradle...

Image


Transmission ready for installation...

Image

Image


Stripped down the constant velocity joint shafts...

Image


Joints cleaned and shafts prepared for painting...

Image


Reassembly...

Image
June 2011

Back from the paint shop...

Image

Image


The paintwork turned out great - I really like the classic dual cutout look...

Image

Image


Mounting the transmission...

Image

Image


CV joint shafts fitted...

Image


Drive train completed...

Image


I banished the tar boards from the engine bay - thus added a final layer of black textured paint.
That stuff is normally used to finish PA speaker cabinets... :D

Image

Image
Previous 1 ... 9, 10, 11, 12, 13 Next
124 posts Page 13 of 13

Who is online

Users browsing this forum: No registered users and 1 guest